Rear Torsion Bar Set for 356 B/C/SC, 24 mm

Product Description:

Rear Torsion Bar Set, 24 mm
For use on 356 models without a compensating spring.  Models that use a compensating spring need to use the 23 mm diameter bar part number 644.333.101.98

These torsion bars are 24 11/16” long.  Check the length on your previously installed torsion bars before ordering. Some 356 cars were produced with shorter bars.

This set includes both left and right Torsion bars.
Part numbers:
695.333.101.03
695.333.102.03

Torsion bars like all springs need to be replaced based on age rather than mileage as the spring is always under load weather it is sitting in the garage or driving down the road. 

Manufacturer Information:

Sway-A-Way torsion bars are a high-performance direct replacement for your stock bars, available in a wide range of diameters to allow you to choose the right spring rate for your application.  Sway-A-Way bars are made with heat-treated aircraft grade alloy steel and centerless ground for vastly improved durability and consistent spring rate.

Sway-A-Way bars are available as a solid or hollow bar, the difference between the two being strictly weight. There is a misconception that hollow bars respond faster but the difference between the two is a handful of nanoseconds. Depending on the bar, the solid could be the “faster” of the two.

Torsion bars are:
     Manufactured from solid 4340 alloy steel
     Heat treated for increased strength
     Centerless ground for consistent outside diameter and rate
     Powder coated to resist corrosion

Reviews and Ratings:

• 1960 Porsche 356B
• 1961 Porsche 356B
• 1962 Porsche 356B
• 1963 Porsche 356B
• 1963 Porsche 356C
• 1964 Porsche 356C
• 1964 Porsche 356SC
• 1965 Porsche 356SC

All returns require pre-approval. All returns are subject to a 25% restocking fee, with the exception of approved warranty returns, or if we ship a different part number than ordered. We do not accept returns after 30 days.

Inspect your order immediately when it arrives. We must be notified within 5 days if there are any missing, damaged, or incorrect parts.

Returns (except warranty) won't be accepted if the part:
 - Has been installed, used, damaged, is dirty or incomplete
 - Is not sellable as new
 - Arrived in sealed packaging that has been opened
 - Is an electrical part, a custom or cut-to-length item, or a Special Order
 - Was purchased more than 30 days earlier

Parts must be returned properly padded in a sturdy cardboard box. Returns sent in envelopes will be refused. Items damaged in transit to us cannot be refunded. All returns must be shipped prepaid.