Part#: 930.602.702.XX.PK
Availability: In Stock
Retrofit of YOUR Bosch 6 Pin CDI Box We'll retrofit your Bosch CDI with our modern electronics. Please note we can't retrofit aftermarket boxes. Exterior cleaning not included; see "exchange" listing if that's needed. For 1978-83 model 911SC and 1978-94 Turbo. Includes free download of CDI System TSB. Send in your old Bosch CDI box, and we will replace its internals with our with our advanced digital CDI electronics package. With a retrofit we don't clean the outside of your case, but we do include new Vorsicht and Pin Layout decals. If you'd like a cleaned up case, see our "Exchange" listing. With the Porsche models that use CDI now as old as 50+ years, many issues are negatively impacting these systems today. Some cars have been fitted with replacement parts that don’t conform to factory standards, and Bosch has discontinued many original parts. Factory specs, knowledge, and diagnosis skills have been forgotten and abandoned. General wear and tear takes its toll over the years. All of these factors contribute to system failures. Advantages of the Partsklassik CDI: • “A” Terminal Disconnect protection • Protected Trigger Signal Input Filter • Input Voltage Correction • End User Settable RPM Limiter • Misfire Over Voltage Protection • True 450 Volt Primary CDI • Highly Efficient Design Resulting in Less Heat Generation • Low System Current Draw • Won’t Lose Power as RPM Increases • Plug compatible with all factory Porsche Models • No Phase Modification on Trigger/Firing Point • 2 Year Warranty Against Defects in Materials and Assembly Each CDI box we rebuild is fully tested on our proprietary testing equipment before it leaves our facility. There are however a number of installation factors, vehicle conditions, and practices that can make a CDI box appear non-functional, or that can actually damage the unit during or after installation. For this reason, we recommend that any CDI box be installed by a qualified Porsche mechanic who is truly competent with Porsche CDI ignition systems. We stand behind our CDI boxes with a 2-year warranty on defects in materials and assembly. When purchasing any CDI box from us, you are responsible for reviewing the warranty statement and following its conditions, including practices to be avoided and issue resolution.
For more info on CDI systems, download our white paper HERE
Partsklassik Partsklassik was founded by a Porsche®-trained mechanic with decades of repair and restoration experience. We are a parts and components restorer, as well as a manufacturer of previously unavailable parts for vintage and classic Porsche® vehicles. We also carry thousands of OEM and aftermarket parts spanning all systems of the air cooled Porsche® models, including the 356, 911, 912, 914, and 930. We continuously add new products and services to meet the needs of the vintage Porsche® enthusiast.
All returns require pre-approval. All returns are subject to a 25% restocking fee, with the exception of approved warranty returns, or if we ship a different part number than ordered. We do not accept returns after 30 days. Inspect your order immediately when it arrives. We must be notified within 5 days if there are any missing, damaged, or incorrect parts. Returns (except warranty) won't be accepted if the part: - Has been installed, used, damaged, is dirty or incomplete - Is not sellable as new - Arrived in sealed packaging that has been opened - Is an electrical part, a distributor spring, a custom or cut-to-length item, or a Special Order - Was purchased more than 30 days earlier Parts must be returned properly padded in a sturdy cardboard box. Returns sent in envelopes will be refused. Items damaged in transit to us cannot be refunded. All returns must be shipped prepaid.