Find Parts & Accesories for your Porsche

The requested page could not be found or no longer exists.
From time to time products will become no longer available and we will turn off the listing so as not to show you something that is not available for purchase. 
Please feel free to contact us if you have any questions..

               
Are you looking for:
Transmission Bearing, Cylindrical Roller Type, Pinion Shaft Cylindrical Roller Bearing
Pinion shaft bearing on 915 transmission.
One required. Photo shows two for detail.
For Porsche 911/912E models from 1972-86.
For 930 models up to 1988.

Sun Visor Set - For 911 / 912 Targa® or Convertible 1969-89 Sun Visor Set, Targa or Convertible
This Sun Visor Set is black on black for Targa and convertible models.
Sold as a set, one left visor and one right.
Mirror is on passenger (right) side. 
Fits 1969-89 models.
Does not fit 1965-68 models; their mounting points are different.

Please note:  This set does not include usable mounting hardware, and you must re-use your existing sun visor mounts. Sun visors need to be installed correctly and the tension screws adjusted so that the sun visor does not fall down while driving. However, if the tension screw is adjusted too tightly, it is possible to damage the factory mounts. If you are unsure about this procedure we suggest that you take your vehicle to an experienced Porsche repair shop to have the sun visors installed
.


Rear Brake Line, Wheel Cylinder to Flex Hose, Left or Right Rear Brake Line, Wheel Cylinder to Flexible Pipe
For the 911 SC hard line to flex line on the rear brakes.
Same line as part number 911.355.621.05.
Fits left or right, sold per each.
Bosch 054 Warm Up Regulator - Outright Sale (No Core Req'd) Bosch Warm Up Regulator 054
Outright sale of a professionally rebuilt unit.
Not for exchange. If sending a core, see our exchange listing.

Bosch 0 438 140 054 was used in the Porsche 930, 10/1977 - 7/1980.
Check your car's original WUR to confirm its Bosch number.
Porsche part number is 930.606.105.03.

Our warm up regulators and fuel distributors are thoroughly cleaned inside and out, then rebuilt by specialized technicians. Processes and tooling are based on Bosch's original manufacturing methods. All units are bench / flow tested to ensure operation within factory specs.

This part carries a One Year repair-only warranty from time of purchase, regardless of mileage or install date. Your fuel system must be properly cleaned out prior to installation, otherwise warranty is invalid.

Transmission Bearing for Pinion Shaft at Intermediate Plate Pinion Bearing in the Intermediate Plate
Annular pinion bearing located in the intermediate plate. This bearing controls the pinion depth for the ring and pinion assembly.

1965-71 for 911 and 912 models.
1970-76 for 914 and 914/6 models.
Also for 911 with the Sportomatic, up to 1983.