Find Parts & Accesories for your Porsche

The requested page could not be found or no longer exists.
From time to time products will become no longer available and we will turn off the listing so as not to show you something that is not available for purchase. 
Please feel free to contact us if you have any questions..

               
Are you looking for:
Heat Exchanger, Turbos 1978-79 Heat Exchanger
Availability varies, please contact us to confirm stock.

For Porsche 930 Turbo 1978-79
For left or right side.
Sold per each; two required per vehicle.
Steel / Painted Grey.
Only for models without Thermal Reactors.
Left Front Fender, 69-73 Dansk New Front Left Fender
Price does not include freight.
Contact us to order and obtain shipping quote.
For Porsche 911 and 912 models from 1969-73
.

Please contact us for a shipping quote before you order. 
Shipping cost will vary by delivery address. We can usually ship this part from one of several US warehouses, including east or west coast. This part is not available for delivery outside the 48 contiguous US States.

Carburetor Pump Discharge Vial Calibration Vial
Porsche® tool number P25a
Sold per each.

This small glass vial comes from Porsche and has ml markings to measure the fuel pump dischage volume on the throttle circuit of your carburetor. The vial must be held down the throat of the carburetor and is best hung on a secured wire. Bench setting the fuel pump discharge volume will greatly assist tuning when the carbs get on the engine.

PLEASE NOTE:  Some disassembly and/or bench measurement will likely be required for Zenith 40TIN carbs, as well as the 911T '69-'71 Webers with 27mm chokes. For these carburetors, there is insufficient room in the throat to lower the vial into position.

Fuel Tank 356 B/C/SC, in Black Fuel Tank, Black 356 B/C
Expected back in stock late Dec '23 / Jan '24.
Contact us to check stock or order.

This is a 52 liter fuel tank in black paint.
For 356 B/C/SC models beginning late '61 (T6).
Made of corrosion resistant aluminized steel.
Tank must be cleaned of potential mfg debris before install.
Also available in Gray paint - see separate listing.

Shipping
May qualify for free ground shipping within the 48 contiguous US states. Some addresses may incur a shipping charge and if that is the case, we will contact you. For expedited shipping, contact us for a quote. This item is not available for shipment outside the US.

Tail Pipe to Muffler Connector Exhaust Y Connection For 912
This metal grey painted exhaust Y is made by the OEM or original equipment manufacturer, Dansk. This is the y part only; it attaches to the muffler on the 912 exhaust system.  Requires two small exhaust clamps.

This Dansk part is an updated design made from round pipe.  It looks different from the original Y that is stamped out.

 Sold per each.