Find Parts & Accesories for your Porsche

The requested page could not be found or no longer exists.
From time to time products will become no longer available and we will turn off the listing so as not to show you something that is not available for purchase. 
Please feel free to contact us if you have any questions..

               
Are you looking for:
Left Front Fender, 69-73 Dansk New Front Left Fender
Price does not include freight.
Contact us to order and obtain shipping quote.
For Porsche 911 and 912 models from 1969-73
.

Please contact us for a shipping quote before you order. 
Shipping cost will vary by delivery address. We can usually ship this part from one of several US warehouses, including east or west coast. This part is not available for delivery outside the 48 contiguous US States.

Screw for Solex Spring Bracket Solex Top Plate Screw For Spring Bracket
Screw that holds the spring bracket to top of carb.
Use a wave or spring washer under this screw.
Sold per each, one required per carburetor.

Tail Pipe to Muffler Connector Exhaust Y Connection For 912
This metal grey painted exhaust Y is made by the OEM or original equipment manufacturer, Dansk. This is the y part only; it attaches to the muffler on the 912 exhaust system.  Requires two small exhaust clamps.

This Dansk part is an updated design made from round pipe.  It looks different from the original Y that is stamped out.

 Sold per each.

Engine Oil Thermostat, 1965-71 Engine Oil Thermostat
Special order item.
Contact us to confirm lead time or to order.
May take up to 3 weeks to ship.

Engine oil thermostat located in the rear of the engine block.
Controls the flow of oil through the engine mounted oil cooler.
For 1965-71 Porsche 911 / 914-6 using the short style thermostat.

Oil Filter Decal, Fram Einlass Fram Einlass, Orange and Black
Mounted just under the inlet pipe of the oil filter canister.
Water transfer type decal. Sold per each.

Identifying your oil filter type for decal selection:
Though all 356 and 912 models will take the same part numbered filter, the decals were used to show the original supplier to Porsche®. The early 356 pre-A and 356A used primarily Mann filters; the Mann filter housing is usually identified by a 10m/m bolt used to hold the filter lid on. The most common filter types will be the H-filter and the Fram filter. The H-filter will use a 16m/m bolt to attach the lid to the canister, and the Fram filter will use a 12m/m bolt. Though you can also use the canister and lid colors to indicate what the original supplier was, it is best to use the bolt sizes as the paint can be wrong.